Broward County Certificate of Competency 20-F-21966-X
Fence Installation & Repair before the next storm in Broadview Park, FL
Fence Installation & Repair for homes in Broadview Park and the rest of Broward County. Free estimate.
Broadview Park is older, unincorporated Broward housing: block homes from roughly the 1950s through the 1970s, carports, and chain-link or aluminum gates in places like Melrose Park, Riverland and Washington Park. If a fence section has leaned, split or come down after a thunderstorm, it usually means the original posts, footings or hardware were never built for today's High-Velocity Hurricane Zone (HVHZ) wind loads, or that humidity and termites have weakened wood over the years.
Cat 5 Home Shield installs and repairs privacy, pool and decorative fences, plus driveway and walk gates, anywhere in Broward County. We hold Broward County Certificate of Competency 20-F-21966-X for fencing. We start with a free estimate, handle the permit application with the survey, schedule the final inspection, and close out the permit.
All of Broward sits in the HVHZ, so a fence here is a wind-loaded structure, not just a boundary line. Panels and gates act like sails in tropical-storm and hurricane wind. Older Broadview Park yards often have original chain-link, aluminum or wood fencing, and onshore sea breezes and constant humidity corrode gate hardware and rot wood posts. Many lots are modest, so height and setback limits, corner visibility and easements can differ from one yard to the next. Where a pool is present, Florida's barrier rules add height, no-climb spacing and gate requirements.
Problems to watch for in Broadview Park
Leaning or fallen sections after storms
Wind-driven rain softens the ground, and thunderstorms routinely topple wood and vinyl fence sections across Broward. Often the fix is re-setting posts with proper footings, not just standing panels back up.
Rotted wood posts and rails
Humidity, the rainy season and a high water table invite rot and termites at the base of wood posts. Once the post goes, the whole run loses its strength against wind.
Rusted chain-link and gate hardware
Salt and moisture carried by sea breezes corrode hinges, latches, drop rods and fittings. A gate that sags or won't latch is also a weak point in wind.
Old fences not built for HVHZ wind loads
Fences from the postwar housing era were rarely designed for current wind-load provisions. Replacement panels and gates may need a Miami-Dade NOA or Florida Product Approval, depending on the product.
Pool barrier that does not meet current rules
Barrier height, no-climb spacing, and self-closing, self-latching gates that open outward away from the pool all matter. Our Florida Pool Barrier Checker is a free way to review your setup first.
Height or setback conflicts
Limits can differ by yard, and corner lots and easements add restrictions. We check these before building so the fence does not have to be moved later.
Driveway gates that drag or fail
Carport and driveway openings in older Broadview Park lots often have aluminum or chain-link gates that have shifted or corroded. They can be repaired or replaced with hardware suited to the climate.
What we do
- Privacy, pool and decorative fencesWe install wood, vinyl, aluminum and chain link, matching the material to the yard, the wind exposure and the pool barrier rules where they apply.
- Driveway and walk gatesNew gates and gate repairs, including self-closing, self-latching gates for pool areas that open outward away from the pool.
- Repairs and section replacementWe re-set posts, replace rotted members and swap damaged panels, and tell you plainly when a run is better replaced than patched.
- Permit application with surveyWe prepare the permit application, work from your survey, and check height, setbacks and easements. Verify with the building department for your address.
- Final inspection and close-outWe schedule the inspections and follow the permit through to close-out, using products approved for the HVHZ.
Permits, codes and licensing in Broadview Park
Fence work in Broward starts with the building and zoning rules. A permit is typically required for new fences and walls and for substantial replacement. In unincorporated areas, permits generally come from Broward County Building Code Services, so verify with the building department which office handles your address. Review covers height, setbacks, corner visibility, easements and property lines, and a survey is often requested. The Florida Building Code applies, including HVHZ wind-load provisions, and products such as aluminum or vinyl fencing may need Florida Product Approval or a Miami-Dade NOA. Pool barriers must also meet the Florida Building Code and Florida's residential pool safety law. Florida does not issue a standard statewide fence contractor license through the Construction Industry Licensing Board (DBPR). Fence contractors are usually licensed or registered at the county or city level, and structural work such as masonry walls may need a state-licensed contractor. Check requirements with the Broward County Central Examining Boards, your building office and DBPR. Our fencing work is covered by Broward County Certificate of Competency 20-F-21966-X. If you live in an HOA or a multifamily building, association approval may also be needed.
Fence Installation & Repair work is done under Broward County Certificate of Competency 20-F-21966-X.
When to call
Fence work goes on year-round in Broward but is easiest in the November to April dry season. Requests tend to rise before hurricane season, which runs June 1 to November 30 and peaks from August to October. In winter, returning seasonal residents often take on deferred repairs. If a section is down now, call (954) 906-1715 or use the quote form on this page for a free estimate. Permit review takes time, so starting early helps.
We serve Broadview Park and nearby Broward areas including Melrose Park, Riverland, Roosevelt Gardens, Washington Park, Boulevard Gardens, Franklin Park, Plantation Gateway, Jacaranda, Pine Island Ridge and Rock Island.
Fencing in Broadview Park: questions we hear
- Do I need a permit to replace a fence in Broadview Park?
- A permit is typically required for new fences and for substantial replacement, with zoning review of height and setbacks. Broadview Park is unincorporated, so permits generally come through Broward County Building Code Services. Verify with the building department for your address.
- Why do older Broadview Park fences fail in storms?
- Many yards here still have fencing from the postwar housing era, built before current HVHZ wind-load provisions. Humidity, rot, termites and corroded hardware weaken posts and gates over time, so sections can fail in strong wind.
- Does my fence need a Miami-Dade NOA?
- Broward is in the HVHZ, and some fence products, such as aluminum or vinyl systems, may require Florida Product Approval or a Miami-Dade NOA. We use approved products and can confirm what applies to your fence during the estimate.
- What are the rules for a fence around a pool?
- Florida's pool barrier rules cover barrier height, no-climb spacing, and self-closing, self-latching gates that open outward away from the pool. Try the free Florida Pool Barrier Checker on this site, then confirm details with the building department.
- Will a new fence lower my insurance cost?
- Florida law (s. 627.0629, Florida Statutes) requires insurers to offer discounts for wind-loss-mitigation features. Fences are not one of the categories on form OIR-B1-1802, so we make no promise of a credit. The free Wind Mitigation Credit Checker can show what the form does cover.
Get a free fencing estimate in Broadview Park
Tell us what's going on. We'll get back to you to set up a visit.
Prefer to talk?
(954) 906-1715