Broward County Certificate of Competency 20-F-21966-X
Fence Installation & Repair in Franklin Park, FL
Fence Installation & Repair for homes in Franklin Park and the rest of Broward County. Free estimate.
Franklin Park sits inside Broward County, and the entire county is in the Florida Building Code's High-Velocity Hurricane Zone. That matters for fences as much as for roofs and openings: fence and wall structures here have to be designed for wind loads under HVHZ provisions, because a panel or a wide driveway gate is a large surface catching wind-driven rain and gusts during the May–October rainy season and the June 1–November 30 hurricane season.
Cat 5 Home Shield builds and repairs privacy, pool and decorative fences in wood, vinyl, aluminum and chain link, plus driveway and walk gates, for homes across Broward County. We handle the permit application with a survey where one is needed, schedule the inspection, and see the permit closed out. Estimates are free — call (954) 906-1715 or use the quote form on this page.
Franklin Park is one of several small unincorporated Broward communities wedged between Fort Lauderdale, Lauderdale Lakes and Oakland Park, with modest single-family concrete-block homes built roughly from the 1950s through the 1970s on small lots. On that housing stock, original chain-link and wrought-iron gates and exterior hardware show heavy rust and pitting from year-round humidity and salt-laden air drifting in from the Atlantic about five miles east. Because the pocket is unincorporated, permits may come from Broward County Building Code Services rather than a municipal office, and formal HOAs are uncommon here even though they are typical of newer subdivisions in surrounding municipalities — verify which office reviews your lot with the city's or county's building department before ordering material.
Problems to watch for in Franklin Park
Rusted chain-link and wrought-iron gates
Humidity and coastal air corrode hinges, latches and frames on the older metal fencing common to this mid-century housing stock. Pitted hardware tends to bind first, then the gate drops out of square.
Wood rot and termites
South Florida's year-round moisture drives rot at posts and rails, and termites follow damp wood. Rot usually shows up at grade level long before the panel above it looks tired.
Storm-damaged panels and gates
Severe thunderstorms and hurricanes routinely topple wood and vinyl fence sections across Broward. In a strong storm, an under-anchored panel or an oversized driveway gate can take the post with it.
Pool barriers that no longer comply
Florida Building Code pool barrier requirements and Florida's residential pool safety law set barrier height, no-climb spacing, and self-closing, self-latching gates that open outward away from the pool. Older gates with worn hinges often stop latching on their own.
Height and setback surprises
Zoning review looks at height and setbacks that differ by yard, corner visibility, and location relative to easements and property lines. On the small lots common in this area, a few inches can decide whether a line is approvable.
Product approval gaps
Aluminum or vinyl fencing products may require Florida Product Approval or a Miami-Dade Notice of Acceptance to be used in the HVHZ. Material bought without that paperwork can stall an inspection.
Permits left open
A fence permit that never passes final inspection stays open on the property record. We schedule the inspection and follow the permit through to close-out.
What we do
- Privacy fencing in wood and vinylNew privacy runs sized and anchored for HVHZ wind loads, with post depth and spacing suited to the small lots and block-home layouts common in Franklin Park.
- Aluminum and chain-link fencingDecorative aluminum and chain link, including replacement of corroded older runs. We use products carrying Florida Product Approval or a Miami-Dade NOA where that approval is required.
- Pool barriers and safety gatesPool fencing set to Florida Building Code barrier requirements, with self-closing, self-latching gates that open outward away from the water.
- Driveway and walk gatesGates hung on hardware chosen with salt-air corrosion in mind, braced so wide leaves stay square in wind.
- Repairs and section replacementPost resets, rail and picket replacement, gate realignment and hardware swaps after storm or rot damage.
- Permit application, survey and inspectionWe prepare the permit application with your survey when one is requested, meet the inspector, and close the permit out.
Permits, codes and licensing in Franklin Park
Florida does not issue a statewide fence contractor license as a standard CILB classification; fence installation is most often licensed or registered at the county or municipal level, and larger or structural work such as masonry walls may require a state-licensed contractor. Cat 5 Home Shield holds Broward County Certificate of Competency 20-F-21966-X, which covers fence work. Contractor qualification and local registration in Broward run through the Broward County Central Examining Boards, with code administration overseen by the Broward County Board of Rules and Appeals, and statewide licensing through the Florida Department of Business and Professional Regulation (DBPR) and its Construction Industry Licensing Board — verify requirements for a specific project with those offices. A permit is typically required for new fences and walls and for substantial replacement, with zoning review for height, setbacks, corner visibility and easements; permits come from the municipal building/zoning department or from Broward County Building Code Services in unincorporated areas, a survey is often requested, and HOA approval is commonly required where an association exists.
Fence Installation & Repair work is done under Broward County Certificate of Competency 20-F-21966-X.
When to call
Fence work runs year-round in Broward, but it is easiest during the November–April dry season, when near-daily afternoon thunderstorms are less of a factor and seasonal residents are back scheduling deferred repairs. Demand rises in spring and again after hurricanes and severe thunderstorms, so permit and survey lead times are worth planning around if you want a line set before hurricane season starts on June 1. Call (954) 906-1715 or request a free estimate with the form on this page.
We serve Franklin Park and nearby Broward County areas including Boulevard Gardens, Roosevelt Gardens, Washington Park, Melrose Park, Broadview Park, Lauderdale Manors, Rock Island, Dorsey-Riverbend, Oakland Park and Lauderdale Lakes.
Fencing in Franklin Park: questions we hear
- Do I need a permit for a fence in Franklin Park?
- A permit is typically required for new fences and walls and for substantial replacement, along with zoning review for height, setbacks and easements. Franklin Park is an unincorporated Broward pocket, so the review may come from Broward County Building Code Services rather than a municipal office — verify with the building department that covers your parcel.
- Does the High-Velocity Hurricane Zone apply to fences?
- Yes. All of Broward County is in the HVHZ, so fence and wall structures are designed for wind loads under HVHZ provisions. Products such as aluminum or vinyl fencing may also require Florida Product Approval or a Miami-Dade Notice of Acceptance.
- Will a new fence earn an insurance wind-mitigation credit?
- A fence is not one of the categories recorded on Florida's uniform mitigation verification form OIR-B1-1802, which covers building code, roof covering, roof deck attachment, roof-to-wall attachment, roof geometry, secondary water resistance and opening protection. Florida law requires insurers to offer discounts for wind-loss-mitigation features (s. 627.0629, Florida Statutes), and a licensed inspector completes that form. You can use the free Wind Mitigation Credit Checker on this site to see which features apply to your home.
- What are the rules for a pool fence?
- Florida Building Code pool barrier requirements and Florida's residential pool safety law address barrier height, no-climb spacing, and gates that are self-closing and self-latching and swing outward away from the pool. We build to those requirements and can replace gate hardware that no longer latches on its own.
- Which fence material holds up in this part of Broward?
- Humidity drives wood rot and termites, and salt-laden air from the Atlantic about five miles east pits metal hardware, which is why many original chain-link and wrought-iron gates here are heavily rusted. Aluminum and vinyl are not subject to rot or termites, while wood and chain link remain practical choices when hardware and finishes are selected for the conditions. We will walk the line with you at the free estimate.
Fencing in nearby cities
Get a free fencing estimate in Franklin Park
Tell us what's going on. We'll get back to you to set up a visit.
Prefer to talk?
(954) 906-1715